Logo
HOME
ButtonButtonButtonButton
 

Services

img   Plumbing
img  
Water heater
img  
Drain Cleaning
img  
AC Systems
img  
Toilet
img  
Hot Water Circulator
img  
New Construction
img  
Leaking Detection and Repair
img  
Faucets and Fixtures
img  
Residential Remodeling
img  
Heating
 
 

Toilet:

 

If you are installing a new toilet, it will have to be assembled and instructions are included with the product. Following the instructions, you will mount the toilet tank to the base using a rubber seal, two bolts with wing nuts, four metal washers and four rubber washers.

To mount the tank, place the rubber seal around the hole on the bottom outside of the tank. The seal is flat on the tank side. Place the tank on the toilet base.

Now put one metal washer and one rubber washer on each bolt. The rubber washer must be against the ceramic of the toilet. Insert the bolts through the inside of the tank and down through the base. Install the rubber washers, metal washers and wing nuts from underneath. Tighten the wing nuts alternately, being careful not to over tighten them as you could break the toilet. Make sure not to overheat it as it is wax and it will melt.